surfasfen.blogg.se - Infiniti front license plate holder 2014 q50

#Infiniti front license plate holder 2014 q50 how to#
#Infiniti front license plate holder 2014 q50 series#

Once established, before removing the bulb holders, unplug the holders for less complicated access.From the inside of the trunk, you have to remove the lining of the trunk, held by clips, you will have to lever softly on all the frame of the trunk to remove it.Locate the location of your light bulbs from the outside.

Unplug the battery from your Infiniti Q50.

In such a case, here is the solution to conduct this operation:

#Infiniti front license plate holder 2014 q50 how to#

How to swap the rear license plate bulb on my Infiniti Q50įinally last option, you must swap the bulb on the backplate of your Infiniti Q50, but you cannot open the cover from the outside of your vehicle. To swap the one on the front plate, nothing could be easier, you will have to position yourself under the vehicle (ideally positioned on candles to give you some space), and, going through the rear of the bumper, you will have to unclip the license plate bulb block, usually held by two soft plastic tabs by pressing on both simultaneously, then now that you have your license plate bulb block in hand, Take off the plastic that acts as a seal, then with a thin screwdriver, on one side you will find a small notch, use a lever to open the plastic cover (be attentive not to apply too much force otherwise you will break the plastic cover), and you will only have to take off the burnt-out license plate bulb and change it with the new, then test and reassemble the whole thing. How to swap the front license plate bulb on my Infiniti Q50

#Infiniti front license plate holder 2014 q50 series#

In most cases you will be able to access it, however some series (often at the rear does not allow this access). Second part of our content, replace this license plate bulb on your Infiniti Q50 without external access. How to change the number plate bulb on your Infiniti Q50 without outside access

Last step, before reassembling, reconnect your battery and test the light to validate the successfulness of the procedure.

Finally, position the new license plate light bulb.

Use your screwdriver or knife to eject the bulb from its location, if you are scared of damaging a thing, you can as well do it with your fingers.

Face your license plate and use a flat screwdriver or knife to place the flat part into the notch supplied for this intent (usually on the transparent cover) and lever on the plastic window to open the license plate bulb slot of your Infiniti Q50.

With the engine turned off, unplug the battery terminals from your car.

Here are a few simple steps to stick to to conduct this maintenance tasks: Whether it’s the front or the back of your vehicle the procedure will be identical. So let’s begin with swapping the number plate bulb by going through the outside of your Infiniti Q50. Unfortunately on some years or packages of car these covers do not open from the outside and if this is the situation we will dedicate a moment on in the second part of this article content to teach you the method. This method is the least difficult of the two, in reality, for this one you will just have to take off the protective covers of the bulbs.